| Post 1 made on Sunday August 15, 2010 at 13:17 |
electrophagos Lurking Member |
|
|
For those who have some basic skills in electronics, I have written an article on how to add a "power on" code to any device by adding a second IR decoder that will "listen" in parallel to the IR receiver's output and power up the device explicitely only when it was in standby mode upon reception of a freely selectable "power on" code. The article is available here: mikro.ee.tu-berlin.de/~bauer/Discrete_power_on_codes_en.htm
|
|
| Post 2 made on Sunday August 22, 2010 at 15:56 |
Dundas Founding Member |
Joined:
Posts: | April 2002
331 |
|
|
Thanks for this, I think I'll give it a try and the SIS-2 with it's discrete button mode is something I've been looking for years.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
