Post 1 made on Tuesday August 25, 2009 at 20:43 |
etrounce Lurking Member |
Joined: Posts: | August 2009 2 |
|
|
Hi,
I just switched from a 6100 to a 6131 and my on/off macros no longer work (though all of the IR commands seem to be the same). I used to use INFO-POWER-POWER for on and INFO-POWER for off. Anyone found new macros or, even better, discrete on/off codes?
Thanks ET
|
|
OP | Post 2 made on Thursday September 10, 2009 at 15:44 |
etrounce Lurking Member |
Joined: Posts: | August 2009 2 |
|
|
Here's my contribution to the community. Someone over at the digitalhome.ca forums provided me the answer so I thought I'd share:
"Press SAT on the 6131 remote until the lights flash. Press POWER. Then press VOL UP to turn the receiver on or VOL DOWN to turn the receiver off."
If you follow this procedure, the 6131 remote will emit discrete power on and power off codes which can be captured by any learning remote. Worked like a charm for me!
|
|
Post 3 made on Sunday April 10, 2011 at 22:46 |
dev-ocg Lurking Member |
Joined: Posts: | December 2008 5 |
|
|
Could someone share all the CCF codes for the ExpressVu 6131? I've been digging through a bunch of ICF and other files but am only getting snippets.
I would REALLY appreciate it...
Thanks
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.