Your Universal Remote Control Center
RemoteCentral.com
Discrete Code Hunter Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Topic:
Denon AVR 687 Inputs
This thread has 4 replies. Displaying all posts.
Post 1 made on Wednesday July 30, 2008 at 19:22
Lcp
Long Time Member
Joined:
Posts:
July 2008
10
Hello, first of all i am very new with IR signals/Remotes so forgive any stupidities i may type :D.

I am currently looking for some discrete input selection HEX codes for an denon receiver

So far all i could find is this [Link: remotecentral.com]

Does anyone know where to get them?
Post 2 made on Thursday July 31, 2008 at 15:55
Rob100
Long Time Member
Joined:
Posts:
July 2007
79
Pretty much all Denon receivers use roughly the same IR codes (some later models use Kaseikyo as well as Sharp codes - I'd think the 687 only uses Sharp codes), although the names of inputs can change slightly. I can't find a doc specifically for the 687, but it probably follows the pattern on the 688, so I suggest you get the following PDF:

[Link: usa.denon.com]

Then have a read of

[Link: remotecentral.com]

and

[Link: remotecentral.com]

Last edited by Rob100 on July 31, 2008 16:02.
OP | Post 3 made on Thursday July 31, 2008 at 22:21
Lcp
Long Time Member
Joined:
Posts:
July 2008
10
Hey, thanks for the reply i am now using the DENONHEX tool, But I can't get it to work right

Your instructions are:

For Sharp:

1) Enter the System Address and Extension Bits.

2) Enter the Data in either decimal or binary (toggle with check box).

But i do not know where to enter the

System address (C1~C5): 01000
Extension Bits (C12,C13): 11

and this code: (not available in KASEIKYO)

Last edited by Lcp on August 1, 2008 00:08.
Post 4 made on Friday August 1, 2008 at 00:43
Rob100
Long Time Member
Joined:
Posts:
July 2007
79
Like this...

OP | Post 5 made on Friday August 1, 2008 at 09:41
Lcp
Long Time Member
Joined:
Posts:
July 2008
10
Whoa this works like magic :D, thanks i was using the other version of your program (the one without sharp), nice program!

Thanks again


Jump to


Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse