Post 1 made on Thursday February 14, 2008 at 00:49 |
winesmile Active Member |
Joined: Posts: | August 2007 580 |
|
|
Anybody have a file for the Pio receiver??
|
|
Post 2 made on Thursday February 14, 2008 at 08:43 |
NSP01 Advanced Member |
Joined: Posts: | March 2005 834 |
|
|
Use this link and download the VSX-90TXV mxf file. Uses the same controls except for Zone 2 (1017 doesn't have Z2). [Link: pioneerelectronics.com]
|
They call me the "Thread Killer". Just watch! |
|
OP | Post 3 made on Thursday February 14, 2008 at 19:48 |
winesmile Active Member |
Joined: Posts: | August 2007 580 |
|
|
Great thanks! Another question - I've never imported a file using the Uni Browser before. I d/l the file to my desktop and found it with the browser, but how do I use the codes and bring them into the remote receiver device?
|
|
Post 4 made on Thursday February 14, 2008 at 21:36 |
NSP01 Advanced Member |
Joined: Posts: | March 2005 834 |
|
|
I'm writing from memory as I can't get to the 900 software to look. Expand the list of commands in the file then drag and drop the commands that you want. I think that's it. Tomorrow I'll have access to the software and check to see if I'm correct. I think you can also import the file as a Device and it will put the commands where it thinks best. Then you can move them around.
|
They call me the "Thread Killer". Just watch! |
|
OP | Post 5 made on Saturday February 16, 2008 at 15:50 |
winesmile Active Member |
Joined: Posts: | August 2007 580 |
|
|
If you wouldn't mind tellig me how to inport the codes that would be great. For some reason the "help" instructions on my browser wont open and I don't remember how to use the "Universal Browser" HEX editor.
Thanks much.
|
|
Post 6 made on Saturday February 16, 2008 at 20:26 |
NSP01 Advanced Member |
Joined: Posts: | March 2005 834 |
|
|
You can't imnport mxf files so forget that. Use the drag & drop method from the Universal Browser.
|
They call me the "Thread Killer". Just watch! |
|
OP | Post 7 made on Sunday February 17, 2008 at 13:55 |
winesmile Active Member |
Joined: Posts: | August 2007 580 |
|
|
It wont drag nor drop... Hmmmm
|
|
Post 8 made on Sunday February 17, 2008 at 17:13 |
NSP01 Advanced Member |
Joined: Posts: | March 2005 834 |
|
|
When you open the file in Univ Browser go to one of the pages with abbreviated commands (Under basic, Adjust, Tuner, etc.). Each one of those are Drag & Drop. Do it one at a time for the commands that you want to use. You can't drag a group.
|
They call me the "Thread Killer". Just watch! |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.