| Post 1 made on Sunday September 17, 2006 at 00:01 |
lando Lurking Member |
Joined:
Posts: | September 2006
1 |
|
|
What I need to do is flash the IR emitter 14 times per second for a few seconds (preferably 5 seconds). How would I be able to do this with a pronto code?
|
|
| Post 2 made on Sunday September 17, 2006 at 07:33 |
Springs Super Member |
Joined:
Posts: | May 2002
3,238 |
|
|
14 seperate times?
Are you asking about a macro?
You could set a command to repeat for 14 seconds in the duration...
Need more info on what you have and what you are trying to do.
This should be over in Pronto Forum BTW.
|
|
| Post 3 made on Sunday September 17, 2006 at 07:37 |
johnsfine IR Expert |
Joined:
Posts: | September 2002
5,159 |
|
|
How long a flash each time? And which model Pronto?
The old ones tend to transmit exactly what the Pronto Hex specifies, so your request is probably possible. The NG Prontos translate and limit the Pronto Hex, so I doubt it would work.
Also, what tool do you have to measure what the Pronto is sending if on first try it sends something like what you want but not quite right?
If you can tell what it is doing wrong you have a better chance of tweaking the results.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
