Post 1 made on Saturday January 11, 2003 at 21:49 |
dvd Founding Member |
Joined: Posts: | January 2002 69 |
|
|
Installed a rack of equipment which is located in a closet in a room with a plasma screen. Used a xantech 480 dinky link on back side of sony plasma screen.All equipment works (5 items) except new sony vcr. Plasma not the problem. Vcr still doesn't work if i shut plamsa off.Using marantz 5200 remote. Vcr works with av closet door open.Did all possible troubleshooting tests. Customer is using system with closet door open until I can figure out what is going on with the sony vcr. Using 18 gauge unshielded wire between Xantech 789-44 powered connecting block and 480b-00 dinky link IR with IR 286m emitters. never had a problem with a sony vcr before with the same IR equipment and IR is definitely on the IR location of VCR and yes did try other emitters. Does anyone know what could be the problem?
|
|
Post 2 made on Sunday January 12, 2003 at 00:32 |
quest51459 Founding Member |
Joined: Posts: | September 2001 197 |
|
|
The newer sony vcr's are out of the ir frequency range. You have a few choices. One: swap the sony for a mitsubishi. Two: add a second ir friendly table top receiver and tune it to the proper frequency. Either one will work. If need more info feel free to email me at [email protected]. We have installed a vast number of plasmas.
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.