Post 1 made on Monday December 30, 2002 at 08:31 |
gdeschaine Long Time Member |
Joined: Posts: | November 2002 14 |
|
|
customer has a denon 1082 avr with a dvdr connected to it via component video. out of the reciever to fuzitsu plasma via component video and svideo for on screen programming. all was well until dish was installed and connected to reciever via svideo. now the component video from the dvd doesnt work. any ideas?
|
|
Post 2 made on Monday December 30, 2002 at 09:18 |
Tom Ciaramitaro Loyal Member |
Joined: Posts: | May 2002 7,967 |
|
|
It's hard to speculate why that output quit, unless there is a menu option that in a video sense 'mutes' the output that does not do the on-screen.
If I have lots of S inputs and only the single component input (DVD) then I usually just send that one direct to the monitor. Save a cable, save the switching and extra circuitry that the signal must pass through.....
|
There is no truth anymore. Only assertions. The internet world has no interest in truth, only vindication for preconceived assumptions. |
|
Post 3 made on Monday December 30, 2002 at 10:43 |
ONEAC Senior Member |
Joined: Posts: | September 2002 1,059 |
|
|
Try unpluging the Svideo from the dish. The monitor may only Svideo OR Component NOT both.
|
|
Post 4 made on Wednesday January 1, 2003 at 11:45 |
Matt Founding Member |
Joined: Posts: | August 2001 1,802 |
|
|
You have to change the input to your television from s to component input.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.