Anyone know if Samsung TVs have discrete power commands? There are two models, LNS-2351D, and 910MP.

If not, do you think it would harm the monitor to use an X-10 module for power?

hey stew...how bout an email address...I can't send you what I have w/out it.(doc too big to post)

Some model Samsungs have them other don't and some changed the firmware in the production run. Its like getting a car made on Monday or Friday you don't know what type of problems it may have;-) There are some codes in the file sections that you can try. I doubt the 910MP would have them I know the 170mp doesn't.

Thanks for the replies, guys.

Mr2Channel, I have e-mailed you my information.

Bob, I'm pretty sure you're right about the inconsistency. The problem is, that I need all monitors to shut off with one switch by the door. This is for a dental office and he wants to turn on and off everything with a switch at the door. The contractor does not want to install a contactor.

I'm not sure that killing the power is good for the TV anyway. I know that some monitors are okay with it, but I'm not sure about the Samsungs. If so, I could install X-10 modules at each set, and put in an X-10 switch by the door. What do you think?

How about using a Sonance K-2 KP with a Xantech current sensor?
CBCSM1 CSM1 Current Sensor Connecting Block



FEATURES

The CBCSM1 allows the Xantech CSM1 Current Sensor to be used as a general purpose current sensor to sense the power state of a component by detecting the difference in current drawn by the component when it is either ON or OFF and to generate a status signal that can be used to control other equipment

If the codes I sent you do not work, go with what Greg C suggests...many different companies make the necessary widgets to get it to work as stated above...I prefer xantech gear though...my .02

The LNS series, well the 26 and up are all supposed to have discretes, somewhere. I haven't looked to hard, or at all, but was told they are out there. Of course, I'm hesitant to believe this, but forthe 23 and below, samsung and most other manufactures seem to leave those out of the good feature sets.

Thanks guys. I appreciate all your help. Mr. 2, I appreciate your email.

I believe that the most economical way to do this is with X-10 modules. I just hope that it doesn't shorten the life of the TVs and monitors.

X-10 is probably the most economic solution but might not be the best if this is an office building. X-10 can run into a gammut of problems. If the devices are not on the same leg of the phase you will need a phase coupler. Whoever owns the building might not let you add that, plus you would need an electrician. Also, it is very likely you would need repeaters, boosters and filters. If his office is in his house you can do it. You might still need some of the deivces mentioned and it would definitely add to the cost but it would be feasible.

If you still plan on using X-10 I'd get one appliance module and controller and test every outlet extensively first. But, keep in mind that some of these problems can appear at a later date. I'd at least consider some of the Insteon products but I'm not sure if they make a keypad controller, I haven't used any of the Insteon products. Try www.smarthome.com and give them a call. They would have a better idea of your needs for X-10 and Insteon.

I think one of the many keypad systems with power sensing is the way to go. It might be more expensive but could save you in the long run.

Bob