| Post 1 made on Monday April 17, 2006 at 10:03 |
FP Crazy Super Member |
Joined:
Posts: | June 2003
2,940 |
|
|
Anyone ever done this? run one of the 6 outputs of a MRF300 into a standard Xantech connecting block (like a 789-44) and then plug 4 emitters into the connecting block - to control 4 components.
I want to run mutiple emitters from one IR port on a mrf 300. I am out of gated ports (there are only 6) and I don't mind ganging mutiple components on a single port as they are different devices and there would be no control conflicts. I could use dual emitters but prefer teh connectinbg block solution (cleaner and easier for maintenence and troubleshooting down the road)
|
Chasing Ernie's post count, one useless post at a time. |
|
| Post 2 made on Monday April 17, 2006 at 10:26 |
idodishez Select Member |
Joined:
Posts: | May 2003
2,433 |
|
|
yes, Ive done it, and it has worked.
Currently have 3 drapes and my projector running off one port of a MRF300 through a conecting block in my showroom.
(Until I get it all switched over to RTI that is)
|
No, I wont install your plasma with an orange extension cord hanging down the wall. www.customdigitalinc.com |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
