| Post 1 made on Tuesday January 31, 2006 at 23:27 |
riki96 Lurking Member |
Joined:
Posts: | December 2005
3 |
|
|
Hi all! I am a custom installer, and I am new to CI Lounge (love the site BTW). Just wondering if most of you test your wire runs after you finish the pre-wire phase? If so, what methods are you using? Thanks!
|
|
| Post 2 made on Wednesday February 1, 2006 at 00:53 |
netarc Senior Member |
Joined:
Posts: | May 2004
1,348 |
|
|
|
| Post 3 made on Wednesday February 1, 2006 at 12:00 |
tschulte Advanced Member |
Joined:
Posts: | November 2005
808 |
|
|
It depends on the job. Most of the time no, but we are VERY careful and go in AFTER all other trades. If it is a large job, we will use a Validator at rough and trim. A medium house we might use a Resi-Tester. Most of the time we just test at trim though. Never really had a problem.
|
Just my opinion, I could be wrong. |
|
| OP | Post 4 made on Wednesday February 1, 2006 at 12:42 |
riki96 Lurking Member |
Joined:
Posts: | December 2005
3 |
|
|
netarc and tschulte,
Thanks for the info.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
