| Post 1 made on Sunday October 27, 2002 at 16:35 |
thxinstaller Long Time Member |
Joined:
Posts: | October 2002
10 |
|
|
I have an older Sony projector installed in my house and I completely converge it and save it too memory, then after powering it up the next day the blue and red seem to have moved. Any ideas?
|
|
| Post 2 made on Monday October 28, 2002 at 21:43 |
Zephyr007 Long Time Member |
Joined:
Posts: | October 2002
213 |
|
|
Did you save it as the service man setting (Save while on an inactive input)? If you save on an input that just saved a video memory 1-9 or video memory off.
Also you have to hold down memory for 5 seconds to save as the service man setting. When memory comes up on screen as soon as you press the button that only applies as the user save, and will not blanket all inputs.
|
|
|
| OP | Post 3 made on Tuesday October 29, 2002 at 00:03 |
thxinstaller Long Time Member |
Joined:
Posts: | October 2002
10 |
|
|
Yes, I did all the calibrations from the service man menu.Iam only looking to save the calibration for that particular input so there is no need to hold down the memory to blanket each input.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
