Post 1 made on Monday August 5, 2002 at 00:09 |
markhull Lurking Member |
Joined: Posts: | August 2002 2 |
|
|
I am programming a Via! and my client wants to have direct access from his Denon Receiver. I have gone to Denon's web site and found the codes in text format. (1's and 0's) How do I use these codes?
|
|
Post 2 made on Tuesday August 6, 2002 at 00:36 |
tsvisser Founding Member |
Joined: Posts: | March 2002 1,228 |
|
|
Binary code is representative of pulses and pulse widths of a signal... usually transmitted on top of a carrier frequency. Find out what denon considers 0 and 1. An example would be \x80 for 1 and [nul] for 0. Different manufacturers use different standards. Some will actaully translate a single hexidecimal byte into 2 binary bytes. Try converting binary (4 bits) directly into hex and then use one of the various pronto utilities to convert it into a .ccf file. I don't know if Via can use these .ccf files directly, but there must be another utility out there that will do the appropriate conversion if they do not accept .ccf files.
There is actually a pretty decent faq on ir signals on the website that you should check out.
-Tom Visser
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.