Post 1 made on Thursday March 10, 2005 at 21:01 |
noot98 Long Time Member |
Joined: Posts: | February 2005 276 |
|
|
I am using mx800 with xantech pa 1235 via rf controller in different room. I cut the head off an emitter and ran from rf receiver to xantech connecting block and from connecting block to pa 1235 common input. All zones work perfectly except 1 and four. Tried re learning volume up down and on off back into mx800 and resetting pa1235 zone freqs. Help
|
|
Post 2 made on Thursday March 10, 2005 at 22:27 |
vwpower44 Super Member |
Joined: Posts: | August 2004 3,662 |
|
|
I have heard somewhere that you can use a Xantech Amplified connecting block when using the non-buffered outputs on the MRF200/250. Also, does teh IR work, or is it a problme with RF, or Learning. Make sure you have the have the setting on the RC68 programmer to the correct code group, and are using the correct codes. Make sure the IR works before you start with the RF stuff.
Mike
|
Stay Hungry, Stay Foolish... |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.