I have set up a system with an Intellicontrol. I programmed the Intellicontrol with learned codes using the yellow brick. (I do not have access to Intellifile II.) I have programmed a Pronto 7000 to correspond to the devices on the Intellicontrol MSU using the archived Intellicontrol ccf; that is, the Pronto sends out Intellicontrol master and function key codes. The Intellicontrol RF remote seems to control all of my devices without a problem, but the Pronto, although set to RF, controls nothing. I belive that the problem is simply that the Pronto and the Intellicontrol are not on the same channel or ID, and thus the MSU is not recognizing the Pronto signal. It has been suggested to me that the appropriate settings for the codes from the archived ccf is channel 1, ID 0, and the correct dip switch setting for the Intellicontrol remote is All Down. Is this correct? I would appreciate any ideas or assistance.

Thanks in advance

I just double checked the last three configurations that we did that way and all have the following settings:
Intellicontrol: In the intellifile program, all sliders are in thier defualt, all up position. This means the MSU channel is set to defualt.

TSU-7000: All the intellicontrol devices are RF enabled and the RF settings for every device are RF CH = 0 RF ID = 0. Once again these are defualt.

I can send you both the .ifd files and the .pcf file if you like.

Jason

Jason,
Thank you for your prompt reply. It is much appreciated. Believe it or not it was the Niles technicians who told me to put the Intellicontrol sliders in the down position. I was afraid that they would be wrong. I would appreciate the files greatly. Thanks again. You have saved me a lot of work hours and grief.

Cornele