This weekend my Radio Ra2 stopped responding from all interfaces with TC running version 2.0 with an MRX10N in my personal system. Testing the same commands placed on the remote from within Accelerator works fine, every time. It will not trigger the commands from any of the remotes or apps (no keypads currently installed to test). Remotes are TRC1080, TRC180, TRC820, and mobile apps for both iOS and Android. I've removed codes and readded. Added via macro or placing the command right no the buttons. I reset the MRX10, Lutron Main Repeater, Router and switch. I have not factory reset the MRX10 and redownloaded yet. I am wondering if this is an issue with a bad update or something wonky in my systems. Anyone else that has Ra2 integrated with TC 2.0 specifically that can test and report back? I don't have time to call in to tech support right now but hope to later this afternoon.

IP address change or something? Any time something stops working with TC I usually just reboot the TC processor and it usually starts working again.

Nothing changed in the system or lutron. I ended up rebooting the mrx10, main repeater, router, switch, factory reset mrx10, reloaded most up to day lutron module, older version of Lutron module, updated lutron firmware, removed module from project and readded module. Nothing worked. Finally, I changed the IP address of the Main Repeater. It was set to static outside of the DHCP range. Changed it to DHCP and set a Mac reservation. Miraculously, this fixed it. Makes no sense why. The main repeater was pingable from Accelerator and was able to test from Accelerator indicating there was no addressing issue. Weird but at least it's fixed