Your Universal Remote Control Center
RemoteCentral.com
Custom Installers' Lounge Forum - View Post
Previous section Next section Previous page Next page Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Page 2 of 2
Topic:
MX980 CCP ?
This thread has 19 replies. Displaying posts 16 through 20.
Post 16 made on Saturday November 25, 2017 at 09:46
highfigh
Loyal Member
Joined:
Posts:
September 2004
8,311
Be happy you're not trying to update an MSC-400. That only works with WinXP because it's not compatible with FAT64.

Nice job of making it obsolete.
My mechanic told me, "I couldn't repair your brakes, so I made your horn louder."
OP | Post 17 made on Sunday December 3, 2017 at 16:15
imt
Long Time Member
Joined:
Posts:
June 2007
466
On November 22, 2017 at 17:40, goldenzrule said...
Thanks for sending the file Todd. I replied here rather than email just to get others thoughts. One thing I noticed is the Fios is on port 2 in all 3 bases. If I have multiple bases in a house, I typically will place them on different ports on each base. It shouldn't be necessary, but I recall way back being told this is best practice. I don't recall if it was in training or just something I heard along the way. It's one thing to try at least. I would probably change the RFID from the 0(letter) ID to just a number on the MRX2 just to see if it helps as well.

So its been a little while before customer was avail and stopped by today. Turns out the issue was the MRF350 in the family room had the RF light stuck on. It wasn't an interference issue. Was just locked up. Thus, it grabbed all RF commands and sent them to all ports.

After solving that. I moved the antenna further away for extra precaution. I also made sure I put the same components in the rooms on different ports on their prospective base stations. Changed the base stations ID's, etc to prevent further issues, unless it locks up again.

I now have a new question. Just found out customer has the iPhone app for use with his MRX2 and unlike TC its totally independent programming. I did pull it off his iphone into CC. But, I have learned commands for the Lens Memory positions set on his Epson projector on the MX980. Is there any way to copy these learned commands to the iPhone? I don't have the URC IR reader to learn them again. I now have to reprogram a bunch of macros I created today ion the MX980 now to the iPhone app.
Post 18 made on Sunday December 3, 2017 at 16:17
goldenzrule
Loyal Member
Joined:
Posts:
July 2007
8,470
You can always use the Transporter function to grab commands learned in another file.
OP | Post 19 made on Sunday December 3, 2017 at 18:29
imt
Long Time Member
Joined:
Posts:
June 2007
466
Perfect. Thanks.
Post 20 made on Sunday December 3, 2017 at 19:23
goldenzrule
Loyal Member
Joined:
Posts:
July 2007
8,470
You're welcome
Page 2 of 2


Jump to


Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse