On September 5, 2017 at 10:16, highfigh said...
What are you all doing with ATT U-Verse internet? They say they don't have a stand-alone modem and for the models that were used until recently, NAT can't be disabled and it can't be set to Bridge mode. They use only Arris in the Milwaukee area, although they now have gateways that can be set to disable NAT- I'll be trying this with the new one I received last week. I wanted a replacement because WiFi sucked with the one they originally sent (and its replacement). I had been using a Luxul as an access point and that was flawless.
I have been reading comments in a local online bulletin board from people who have ATT and Spectrum- they're having problems with both and they aren't getting good solutions.
so I run into uverse more often than I would like. We still ALWAYS put in a real router as those things are real POS.
Here's how.
Step 1. Put unit into DMZ mode.
Step 2. create static route in Uverse unit to Router (in our case always a mikrotik)
Step. 3 make sure that the uverse unit is providing a WAN connection and not LAN connection to our router.
Step 4. turn off all wifi on the uverse POS.
Step 5. Install anything you want onto the network