| Post 1 made on Thursday November 18, 2004 at 13:39 |
Atik Rat 81 Founding Member |
Joined:
Posts: | April 2002
35 |
|
|
I have a Onkyo CHAD operating via RF in one room, and an MX800 operating via RF in another room. No matter what RF channel and extender I put the CHAD on, the RF receiver for the MX800 still picks up the CHAD's info. Any thoughts?
CHAD on ID#3...extender F
MX800 on ID#0...no extender available
|
|
| Post 2 made on Thursday November 18, 2004 at 14:09 |
diesel Senior Member |
Joined:
Posts: | April 2004
1,177 |
|
|
The MRF200/250 must be set to an ID other than 0. Use the ID 0 to troubleshoot RF problems and then set it to something else.
Matt
|
|
| OP | Post 3 made on Thursday November 18, 2004 at 14:10 |
Atik Rat 81 Founding Member |
Joined:
Posts: | April 2002
35 |
|
|
Universal says ID#0 is a broad spectrum freq. They suggest switching the MX800 to a different frequency once you have your remote dialed in. Makes sense....wish I'd thought of that.....
Ben
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
