| Post 1 made on Tuesday November 16, 2004 at 02:31 |
Tom Ciaramitaro Loyal Member |
Joined:
Posts: | May 2002
7,965 |
|
|
With 6 K2's going to the Harbor, I added the PS2 outboard power supply. It's a little lame that it looks like I get to snip the end off the PS2 and make up some harness to go to keypads 3 thru 6.
Since it's CAT5e I'm connecting to, it's not flexible enough to mess with much. I'm thinking I will solder adjacent + and - connections and tie the 3-4 and 5-6 pair together with a jumper. Then solder to the PS2 wires?
Is there a better way?
Thanks!
=Tom
|
There is no truth anymore. Only assertions. The internet world has no interest in truth, only vindication for preconceived assumptions. |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
