|
|
|
Custom Installers' Lounge Forum - View Post
|
|
|
|
|
|
|
The following page was printed from RemoteCentral.com:
Topic: | Elan TD3000 DA amp This thread has 6 replies. Displaying all posts. |
|
Post 1 made on Saturday July 2, 2016 at 17:52 |
tomciara Loyal Member |
Joined: Posts: | May 2002 7,965 |
|
|
Blowing fuses. It is very convenient, because it fits inside a 14" x 24" tall can, and it feeds three separate zones of audio. I don't know what else would fit in this wall can. Would you try to get it repaired, or put a Crown or some outboard amp in its place?
|
There is no truth anymore. Only assertions. The internet world has no interest in truth, only vindication for preconceived assumptions. |
|
Post 2 made on Saturday July 2, 2016 at 20:22 |
Glackowitz RC Moderator |
Joined: Posts: | May 2002 3,793 |
|
|
Last time I called Elan on a TD amp they didn't know what it was let alone repair it. I did find a guy at Elan eventually and he said repair was not possible. Offered no solution and said I was on my own. Luckily a couple new fuses and it came back to life. The unit had taken a lot of water from a leaky pipe above it.
|
There's no worse feeling than that millisecond you're sure you are going to die after leaning your chair back a little too far. |
|
OP | Post 3 made on Saturday July 2, 2016 at 21:30 |
tomciara Loyal Member |
Joined: Posts: | May 2002 7,965 |
|
|
Is there anything currently available, basically either a 6 to 8 channel amp, or a solid power amp that will work down to 2 ohms, and fit inside a big can? Sounds like an impossibility, but that's why I am asking.
|
There is no truth anymore. Only assertions. The internet world has no interest in truth, only vindication for preconceived assumptions. |
|
Post 4 made on Sunday July 3, 2016 at 06:10 |
thecapnredfish Senior Member |
Joined: Posts: | February 2008 1,397 |
|
|
Do not have an amp in mind, but bury a speaker selector to help with the 2 ohm problem or some resistors. Check out the Parasound Model250
|
|
Post 5 made on Sunday July 3, 2016 at 08:20 |
Don Heany Senior Member |
Joined: Posts: | September 2008 1,178 |
|
|
If it's not responsible for door chime, and isn't providing an 'elan tone' through phones- gut it and make a j-box out of it to the new system of choice.
|
|
Post 6 made on Sunday July 3, 2016 at 09:47 |
ShaferCustoms Long Time Member |
Joined: Posts: | March 2014 380 |
|
|
On July 2, 2016 at 21:30, tomciara said...
Is there anything currently available, basically either a 6 to 8 channel amp, or a solid power amp that will work down to 2 ohms, and fit inside a big can? Sounds like an impossibility, but that's why I am asking. You could get creative and go old school: [Link: crutchfield.com]I used to install Sound Stream systems. Not much difference.
|
|
Post 7 made on Tuesday July 5, 2016 at 14:48 |
Fred Harding Super Member |
Joined: Posts: | October 2001 3,460 |
|
|
The TD product was unique, as I recall. Mono or stereo, paging through speakers, door bell interface, page over ride of attenuation. If you customer wants to forgo some of the features, you certainly explore other options...
|
On the West Coast of Wisconsin |
|
|
Before you can reply to a message... |
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now. |
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
|
|
|
|