Hi hope someone can guide me in the right direction

I have just programmed my s70 and the menu up/down left and right over respond when pressed so if i am say scrolling down channel list it jumps 3 places and sme times even more, i have tryed relearning the code a few times but always the same result.

is there any way of changing the resonse time for a a code in nevo pro 3 or is it something else.

any ideas would be helpful

Paul

Paul, check your repeat settings, which is usually set to 3.
Also, make sure that press and hold (common to vol+/-) is disabled.

Hi Mario

i cant seem to find anything in nevepro 3 to enable checking the repeat time (common to vol+/-) do i need a different piece of software for this or am i just not looking in the right place, i have gone thru all the settngs in the programme with no sucess

thanks for replying

Paul

Come on you guys someone must have an idea on this problem, any advice welome

Thanks Paul

You might want to bump this over to the UEI Nevo forum. The Nevo is long dead in pro-terms but there are still a few DIY guys playing around with them in the other forum.
Not sure about S70 but I do remember that the SL and Studio 2.0 combo could be finicky with learned IR. Maybe try getting the HEX codes for your functions and pasting these directly into your Pro3 file? I think this might be the solution that stops the repeats.