|
|
|
Custom Installers' Lounge Forum - View Post
|
|
|
|
|
|
|
The following page was printed from RemoteCentral.com:
Yamaha RX-A1040 RS232 issue
| |
|
Topic: | Yamaha RX-A1040 RS232 issue This thread has 4 replies. Displaying all posts. |
|
Post 1 made on Friday July 24, 2015 at 11:04 |
Audiophiliac Super Member |
Joined: Posts: | August 2006 3,312 |
|
|
I have this AVR connected to an Elan G1 controller's serial port. The G1 is in extender mode, and SC2 is master. System functions properly until I turn it off and let it sit for a while....not sure how long yet. But when I try to turn it on again after some period of time, the receiver will not power on. If I power it on manually, all the functions work. If I then turn the system off, and back on within a short time, it powers on.
It is like the serial port is turning off. ECO mode and auto-standby are OFF in the receiver setup menu. I tried turning on the network standby function....but it has not been sitting long enough for a proper test, so I will check it when I get back in the office this afternoon.
Any ideas?
|
"When I eat, it is the food that is scared." - Ron Swanson |
|
Post 2 made on Friday July 24, 2015 at 12:22 |
Easton Altree Founding Member |
Joined: Posts: | July 2001 930 |
|
|
Make sure RS-232 standby setting in network setup is properly set
|
|
|
OP | Post 3 made on Friday July 24, 2015 at 14:15 |
Audiophiliac Super Member |
Joined: Posts: | August 2006 3,312 |
|
|
Maybe I am blind, but there is not a setting for "RS232 Standby". There is a "Network standby". Would I be correct to assume that this feature also activates an RS232 standby function? Of course it would be too hard to put this info in the owners manual for hell's sake!
I turned the network standby on before I left this morning but some bum turned on the system while I was gone. I just turned it off again. I will re try again in a couple of hours to confirm.
|
"When I eat, it is the food that is scared." - Ron Swanson |
|
Post 4 made on Friday July 24, 2015 at 18:42 |
KVH Advanced Member |
Joined: Posts: | December 2006 911 |
|
|
Try sending the power on command twice.
|
All high's, all low's, it must be....... Einstein @ URC Control Room forum www.einsteinaudiosystems.com |
|
OP | Post 5 made on Friday July 24, 2015 at 19:04 |
Audiophiliac Super Member |
Joined: Posts: | August 2006 3,312 |
|
|
Seems to work now that I enabled network standby. Go figure. I will check it again after the weekend. It would turn on if I sent the command twice. I did read a thread from several years ago which mentioned that.
|
"When I eat, it is the food that is scared." - Ron Swanson |
|
|
Before you can reply to a message... |
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now. |
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
|
|
|
|