Post 1 made on Thursday October 14, 2004 at 01:54 |
devo Lurking Member |
Joined: Posts: | October 2004 3 |
|
|
Can anyone help me. I can't get the learned ccf vantage codes to work on my mx-800 remote. I downloaded the codes from here and the only way I could get to them was from the universal browser in the mx-800 editor but did not work. Can anyone point me in the right direction to turn on the 10 lighting scenes from the vantage system through my ir keypad with the mx-800.
Thx Devo
|
|
Post 2 made on Friday October 15, 2004 at 07:33 |
dr.k Long Time Member |
Joined: Posts: | February 2004 179 |
|
|
Thx Devo, Were did you download the files from. I have used the files from this site for the Pronto with no problem. Double check that you have the IR zone set in Vantage programming.
|
|
OP | Post 3 made on Friday October 15, 2004 at 11:11 |
devo Lurking Member |
Joined: Posts: | October 2004 3 |
|
|
Thx Dr.
I called Vantage after doing some diagnostics and that in fact was the problem. It was an internal issue with the ir zone # in the q-link program. After I changed the ir zone # it worked like a charm. Vantge tech support was very helpful. Thx for your response.
Devo
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.