Post 1 made on Monday July 12, 2004 at 00:29 |
starlet56 Long Time Member |
|
|
Client did not want an active subwoofer sitting anywhere on floor. I figured I could use the Niles PSW8 passive sub installed into wall( I know!) and take the subwoofer preout of the avr985 receiver to an Atlas Sound subwoofer amp. I only ran 1 16/2 to subwoofer location(sheetrocked now) but when I picked up the sub there is a left and right input!! I was expecting 1 set if +- input on the speaker for the 1 rca subwoofer preout on the receiver. Any thoughts??
|
|
Post 2 made on Monday July 12, 2004 at 00:58 |
Unless it's a dual sub. Just parralell the input.
|
|
Post 3 made on Monday July 12, 2004 at 19:28 |
AVFriend Long Time Member |
Joined: Posts: | June 2004 331 |
|
|
always use 16/4. For now, paralell the input like tekno suggests.
|
|
Post 4 made on Monday July 12, 2004 at 19:55 |
oex Super Member |
Joined: Posts: | April 2004 4,177 |
|
|
ALWAYS run a RG6quad with it too. just in case
|
Diplomacy is the art of saying hire a pro without actually saying hire a pro |
|
OP | Post 5 made on Tuesday July 13, 2004 at 00:16 |
starlet56 Long Time Member |
|
|
Thanks folks... since the amp is 4 ohm stable I will parallel the input as you suggest......
Thanks again
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.