| Post 1 made on Friday July 9, 2004 at 18:52 |
ErikS Active Member |
Joined:
Posts: | July 2003
699 |
|
|
Of those of you who have installed a visionart, what is the pinout of the rj11 jack to connect an ir receiver to the control module? I called visionart but the people who knew apparently had left for the day.
|
|
| Post 2 made on Monday July 26, 2004 at 10:11 |
TerriO Long Time Member |
Joined:
Posts: | January 2003
20 |
|
|
The pinout is as follows,
signal: pin 5
common: pin 3
+12v: pin 2
Hope that helps!
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
