 |
 |
|
|
Custom Installers' Lounge Forum - View Post
|
|
 |
|
|
|
 |
|
The following page was printed from RemoteCentral.com:
| Topic: | Elan System 6 Assistance This thread has 4 replies. Displaying all posts. |
|
| Post 1 made on Friday July 2, 2004 at 18:59 |
dperrier Lurking Member |
Joined:
Posts: | December 2002
9 |
|
|
Two inquiries:
1) How do I use the System6 Source sense inputs to conditionally turn off a device from a Z-PAD? I have managed to get it working fine for power up using a conditional first step
2) How do I use the System6 Source Sense Input from a Via Panel?
Darwin
|
|
| Post 2 made on Saturday July 3, 2004 at 01:54 |
Darwin, I would highly reccomend contacting Elan support. They are extremely knowledgeable about their products, and will be able to walk you through the issue step by step.
|
|
| OP | Post 3 made on Saturday July 3, 2004 at 12:16 |
dperrier Lurking Member |
Joined:
Posts: | December 2002
9 |
|
|
I plan to, but they are closed until the 5th, and what I am trying to do should be quite simple.
|
|
| Post 4 made on Saturday July 3, 2004 at 23:27 |
thefish Founding Member |
Joined:
Posts: | September 2001
1,721 |
|
|
hey darwin,
I'm not sure what you are asking. If you have a conditional first step, and you power up, and the unit is on, the system 6 will skip the forst command.
Press power again and the system should power off.
ZPADs can only store one IR command to a key. Sequence keys can point up to 13 keys where IR commands are stored. Sequence keys do not store IR data but stores pointers to other programmed keys. Because of this, you must program IR to keys on the IR Screen prior to programming a sequence.
Conditional First Step
The Z630 has the ability to detect audio at its source inputs. If audio is detected, the source is on. If audio is not detected the source is off.
Whenever audio is present and the Conditional First Step is checked, the first step in the sequence will not be performed.
From the help:
Whenever audio is not present and the Conditional First Step is checked, the first step in the sequence will be performed.
The first step is meant to be a power command. When used this way, the source equipment can be turned ON if it is OFF.
NOTE: If the source is on but not playing, the ZPAD will execute the PWR command turning the source OFF.
Are you a dealer, if you are, I suggest the Elan U.
|
|
| OP | Post 5 made on Sunday July 4, 2004 at 13:30 |
dperrier Lurking Member |
Joined:
Posts: | December 2002
9 |
|
|
I have the power on working fine from the ZPADs. It's the power OFF of the devices I want to automate.
It is also how to use the source status inputs on the system6 with a via. I have done it with a SR1 before but not just with the system6.
None of the training courses cover this.
|
|
 |
Before you can reply to a message... |
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now. |
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
|
|
|
|
|
