| Post 1 made on Friday February 27, 2004 at 22:40 |
willhopkins Lurking Member |
Joined:
Posts: | February 2004
2 |
|
|
I have just installed a house video distribution system using three sources, two satellite receivers and one TiVo unit. How can I program a Pronto TSU3000 so that the volume can be controlled differently in each room, but have the Pronto use the same source device?
|
|
| Post 2 made on Saturday February 28, 2004 at 00:59 |
Impaqt RC Moderator |
Joined:
Posts: | October 2002
6,233 |
|
|
Your going to need to Duplicate your system three times adjusting the VOlume buttons for each TV setup.
Should not be a memory isssue unless your using SNL
|
|
|
| OP | Post 3 made on Saturday February 28, 2004 at 01:05 |
willhopkins Lurking Member |
Joined:
Posts: | February 2004
2 |
|
|
I was afraid of that. Thanks for the help.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
