| Post 1 made on Thursday January 29, 2004 at 16:34 |
Steve D Founding Member |
Joined:
Posts: | June 2001
211 |
|
|
|
| Post 2 made on Thursday January 29, 2004 at 18:17 |
avdude Founding Member |
Joined:
Posts: | February 2002
814 |
|
|
Steve,
I think so, but can't remember for sure on that model. I know I was in the process of programming for one when it blew up, and the owner replaced it with a panasonic.
If you have the means, throw the input discreets from this site into a programmable remote, and go point at one. All of Toshiba codes have been standard across the line for the last three years (at least on the RPTV's)
good luck
avdude
|
AVDUDE
"It might work better if it were plugged in and programmed first...just a thought!" |
|
| Post 3 made on Friday January 30, 2004 at 17:35 |
bennettavi Active Member |
Joined:
Posts: | August 2003
675 |
|
|
Yes the discrete codes do work. The inputs are a 2 step macro, but the on/off work flawlessly. Use the codes on this site.
|
|
| OP | Post 4 made on Friday January 30, 2004 at 17:39 |
Steve D Founding Member |
Joined:
Posts: | June 2001
211 |
|
|
I figured it out. If you push the TV/Video button all of the inputs are displayed for a few seconds and are numbered. To go directly to an input you push the number from the keypad while the list is still displayed.
The discrete On and Off worked that was listed in the files IR section. I was worried because they are listed as Rear Projection Sets.
Steve
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
