| Post 1 made on Thursday January 22, 2004 at 22:12 |
rknecht Long Time Member |
Joined:
Posts: | December 2003
90 |
|
|
A customer just got a plasma lift cabinet by Hooker. The remote that operates the lift is RF not IR. There is a switch in the inside of the lid that also operates the lift. Is there any way to trigger the lift via IR or 12V trigger? And, IF I can trigger the lift via 12V, can I make it go up and down? I am using a Marantz SR7400 reciever, which has a DC out, and a Pronto 7000NG.
|
|
| Post 2 made on Thursday January 22, 2004 at 23:01 |
Impaqt RC Moderator |
Joined:
Posts: | October 2002
6,233 |
|
|
Chances are your RF remote is simply a garage door opener style interface to a basic Contact closure in the cabinet. Probobly the Switch as well. I never heard of "Hoocker" lifts before, but most I've seen use a similar interface. Look for the actual control board... Not the control interface and you'll see whats triggering the motion.
Either way (12v or CC) a safe interface is a Xantech CC12. Basic IR Controlled relay... It can provie you a Contact closure, or a 12V signal with the use of a basic 12V Power Supply....
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
