| Post 1 made on Wednesday December 17, 2003 at 06:35 |
Shoe Founding Member |
Joined:
Posts: | August 2001
1,385 |
|
|
Does anyone have any first hand knowledge on controlling the HLN series DLP RPs from an rf to ir adaptor like putting an emitter inside the set? Help would be greatly appreciated.
|
|
| Post 2 made on Wednesday December 17, 2003 at 07:42 |
DDeca Long Time Member |
Joined:
Posts: | November 2002
435 |
|
|
We recently installed a HLN with an IntelliControl. We had to take the screen off to get to the sensor located at the bottom center of the set.
The flasher entered the cabinet through a small door at the left rear (when looking at the back of the set) which we had to nocth for the small flasher cable.
Be carefule to keep the flasher cable along the bottom so it is not in front of the bulb. We used a small black zip tie to hole the flasher to the sensor.
The TV won't turn on until all the doors and panels are back on the set, so you have to put it back together before you can test it.
All in all, it was not to difficult and works like a charm!
|
|
| OP | Post 3 made on Thursday December 18, 2003 at 17:37 |
Shoe Founding Member |
Joined:
Posts: | August 2001
1,385 |
|
|
Thank you Ddeca for a concise and knowledgeable answer
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
