Post 1 made on Friday November 7, 2003 at 07:11 |
Trenton Lurking Member |
Joined: Posts: | November 2003 2 |
|
|
IS it possable to interface On-Q lighting controls to the VIA?
|
|
Post 2 made on Friday November 7, 2003 at 09:16 |
jputtcamp Long Time Member |
Joined: Posts: | June 2002 283 |
|
|
I don't know much about On- Q lighting but I do know about VIA's. You can use either a local IR or the system IR port to control lights by IR, or you can buy an SC4 and write RS232 protocol to control a processor or whatever On-Q uses. Elan has not been very supportive of using 232 commands that are not for one of their "special components" but it is possible, just have to dig through thier programming a bit.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.