| Post 1 made on Monday November 3, 2003 at 09:34 |
johnneeukca Long Time Member |
|
|
Hi guys,
Has anybody had any problems with the Niles Solo keypads during installation?
I bought a new keypad for another zone wired it up and get no response. I tested the line by using a keypad from another zone and that worked fine. Also, if I turn on all zones from Zone 1, the source light for the useless keypad in the new zone lights up, but pressing the keys has no effect.
What do you reckon? Is it me r is the Keypad defective?
|
|
| Post 2 made on Monday November 3, 2003 at 17:29 |
avintegrator Long Time Member |
Joined:
Posts: | March 2003
348 |
|
|
We have installed lots and lots of these, over a hundred and i can only remember one or two bad ones, stuff happens
|
|
| Post 3 made on Monday November 3, 2003 at 20:44 |
geraldb Long Time Member |
Joined:
Posts: | June 2002
412 |
|
|
When they first came out I had a couple of them that were bad. They did recognize the problem and quickly addressed it. It's been over a year since I have seen a bad one. They'll swap it for you.
|
|
| Post 4 made on Monday November 3, 2003 at 20:52 |
Impaqt RC Moderator |
Joined:
Posts: | October 2002
6,233 |
|
|
We install 1-2 4630 Systems a week, and have run into a few Bad Keypads. Overall a pretty decent failure rate.... Substantially better than the system we used to install.
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
