Post 1 made on Monday March 11, 2002 at 10:44 |
I have a problem with an AVR 510, and the same problem may be present with other models. When Surfing channels on a Dolby Digital Sat receiver the AVR detects and plays Dolby Digital Audio when broadcast. However when switching back from a Dolby Digital source to Prologic the receiver switches to its default of "Surround off" this is very frustrating. Does anyone know if there is a way to change this Default, or if there is a software upgrade available for this unit.
|
|
Post 2 made on Saturday March 16, 2002 at 19:16 |
DBDElectronics Founding Member |
Joined: Posts: | December 2001 46 |
|
|
|
Post 3 made on Sunday March 17, 2002 at 17:50 |
Larry Fine Loyal Member |
Joined: Posts: | August 2001 5,002 |
|
|
Horizon, the way you worded your question, the unit's default is "Surround off". If so, can't you change the default to be ProLogic? Or are you saying that the default itself changes? Larry www.fineelectricco.com
|
|
|
Post 4 made on Monday March 18, 2002 at 11:14 |
Thon Founding Member |
Joined: Posts: | November 2001 726 |
|
|
If you are using a universal remote, such as Pronto, you could program the surround mode explicitly for each source.
|
How hard can this be? |
|
Post 5 made on Monday March 25, 2002 at 17:38 |
ngavchris Founding Member |
Joined: Posts: | March 2002 103 |
|
|
I have not heard of this problem, and have installed many of the h/k products. The 510 did not have discrete surround modes. However, the new 520 does. Also try the OSD and see if the default surround mode is set to Surround OFF.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.