Post 1 made on Saturday March 9, 2002 at 19:32 |
daytech Founding Member |
Joined: Posts: | December 2001 29 |
|
|
Has anyone had problems with these 2 pieces? i get a 1/2in space on each side of the plasma, even when all settings are correct, any ideas?
It is conected via the rca "15pin to component switch" that rca provided.
thanks
|
|
Post 2 made on Saturday March 9, 2002 at 21:28 |
John Pechulis Loyal Member |
Joined: Posts: | July 2001 7,127 |
|
|
Go into the menu of the DTC-100 and select number 7, assisstance.
Then select number 8, monitor setup.
Select number 2, retrace timing.
Select Short retrace (EIA 770.3 Timing)
Select continue, then power off the DTC-100.
Power up the DTC-100 and that should take care of the problem.
We've had to make this adjustment for every DTC-100/Pioneer plasma we've had to install.
JJP
By the way, are you using the BNC RGB input? (Input 3)
This message was edited by John Pechulis on 03/09/02 22:00.48.
|
|
OP | Post 3 made on Wednesday March 13, 2002 at 21:25 |
daytech Founding Member |
Joined: Posts: | December 2001 29 |
|
|
worked like a champ thanks!!!
|
|
Post 4 made on Wednesday March 13, 2002 at 21:35 |
John Pechulis Loyal Member |
Joined: Posts: | July 2001 7,127 |
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.