| Post 1 made on Tuesday June 24, 2003 at 16:36 |
I have a group of components hooked up through an RF transmitter and I need to hook up the IR sensors to the components. If I use the double sided tape it doesn't stick for too long before falling off. Now there is very weak and unstable scotch tape on the IR sensors and I need something that will stick and not affect the IR eye.
Any suggestions?
Thanks
|
|
| Post 2 made on Tuesday June 24, 2003 at 17:09 |
Steve D Founding Member |
Joined:
Posts: | June 2001
211 |
|
|
I first clean the area with isopropal alcohol and then use a drop of hot glue. They still come off but not as much.
Hope this helps
Steve
|
|
| Post 3 made on Tuesday June 24, 2003 at 23:45 |
cb1 Select Member |
Joined:
Posts: | September 2002
1,663 |
|
|
Use clear silicone, works great. Hold in place for a few hours with electical tape.
CB1
|
why have a nice system if you cant operate it, program the remote the right way the FIRST time! |
|
| Post 4 made on Wednesday June 25, 2003 at 18:43 |
studiocats1 Long Time Member |
Joined:
Posts: | February 2003
482 |
|
|
Why not take it to the next level and open up the gear and hide the emitter inside. It makes for a very clean install and you don't have to worry about them falling off.
My two.
|
|
| Post 5 made on Tuesday July 1, 2003 at 00:22 |
mikeintx Long Time Member |
Joined:
Posts: | February 2003
62 |
|
|
can also use flasher covers, if the manufacturer for your flashers makes them. also eliminates cross-crontrol between products of same brand.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
