Post 1 made on Wednesday May 21, 2003 at 14:53 |
Quadrant Systems Lurking Member |
|
|
I've got a Runco VX1000 installed in a barreled ceiling, and is pushed the very back of a room. The "TEMP" warning came up a few times, and once the projector actually went into a thermal shutdown (basically disables the projector until you kill power to it). Any ideas on how I can get some better airflow going on?
|
|
Post 2 made on Friday May 23, 2003 at 13:30 |
Ted Wetzel Founding Member |
Joined: Posts: | November 2001 879 |
|
|
not without majore surgery. return duct over the projector to pull off the heat.
|
|
Post 3 made on Tuesday May 27, 2003 at 12:03 |
Sounds like you dont have enough open airspace behind the unit. You need to install some ducting to bring air to the unit.
|
|
Post 4 made on Wednesday May 28, 2003 at 14:20 |
We've had to replace the runco with a sim2seleco. could never cool it off enough in a soffet
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.