Your Universal Remote Control Center
RemoteCentral.com
Custom Installers' Lounge Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Topic:
NEC Plasma won't power on
This thread has 2 replies. Displaying all posts.
Post 1 made on Tuesday April 15, 2003 at 20:07
BBHOME
Long Time Member
Joined:
Posts:
February 2003
21
I was at a client's house today that has a NEC PlasmaSync 3300. When the set is powered on, the green light flashes but it will not power on. I've seen this on Mitsu sets, but eventually they will power up. I know NEC and Mitsu are the same, but can't figure this one out.
Thank You,
Chris
Post 2 made on Tuesday April 15, 2003 at 21:18
avdude
Founding Member
Joined:
Posts:
February 2002
814
BB...

Don't know if this is it, but NEC's newer plasmas will go green, then flash green, then go yellow if they don't sense a signal. On the newer ones, you can getinto the setup, and turn this feature off. Try changing inputs, and make sure you are presenting it with a signal

avdude

www.integrationpros.com
AVDUDE
"It might work better if it were plugged in and programmed first...just a thought!"
OP | Post 3 made on Tuesday April 15, 2003 at 21:22
BBHOME
Long Time Member
Joined:
Posts:
February 2003
21
I'll give it a try, but this unit is three years old.
Chris


Jump to


Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse