| Post 1 made on Sunday November 10, 2019 at 21:46 |
ChrisP69 Long Time Member |
Joined:
Posts: | February 2011
45 |
|
|
Going crazy. I have a tsu 9400 purchased used a few years ago, been working great until tonite. I moved one button in my config (pep2) from one page to another, downloaded config. Now some hard buttons not sending ir signal.
buttons not working are, mute - ok - menu - volume+ - left dot - right dot - power. If I send test code from my database it works. I tried reset, home - menu -page up no good. I removed battery no good. Is there a reset button on unit? Any help would be appreciated. 9400 specs application 5.0.6 ir firmware 3.0.11
|
|
| OP | Post 2 made on Sunday November 10, 2019 at 22:07 |
ChrisP69 Long Time Member |
Joined:
Posts: | February 2011
45 |
|
|
Working correctly now not sure about fix powered unit off for 20 mins then downloaded again works.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
