Post 1 made on Thursday May 2, 2019 at 00:04 |
I've spent the entire day trying to figure this out and I'm at the end of my rope. I'm trying to set-up and use a second preamp. The existing config file has been fine for my other devices, but now I'm noticing that the second preamp's screen is greyed out and none of the buttons will work. So, is there some way to make this active??? I've gone through the set-up screens ad-infinatum and made sure there's a brand, a codeset, etc. I can't determine why it's greyed out... Thanks
|
|
Post 2 made on Friday May 3, 2019 at 19:40 |
Lyndel McGee RC Moderator |
Joined: Posts: | August 2001 12,995 |
|
|
Wrong forum (You want the NG forum for a TSU7500) but I do have questions for you. Bear with me because I've not had one of these remotes for over 9 years.
1. Did you use a PC to setup the 2nd Pre-Amp 'Device' or are you trying to do so on the remote itself?
2. Is this button that is grayed out on the 'Devices' page or on a page that is jumped to after pressing 'Preamp 2'? If the buttons are on this 2nd page, they won't be pressable until you assign a function to them or load an IR code into them.
3. Did you try to upload your config from the device to a PC? If you've done that, could you please email me the config to the address on my profile and I can take a look over the weekend.
Lyndel
|
Lyndel McGee Philips Pronto Addict/Beta Tester
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.