Post 1 made on Tuesday July 21, 2015 at 22:17 |
manc01 Founding Member |
Joined: Posts: | April 2002 189 |
|
|
Hi there,
Well unfortunately I seem to have deleted the current mxcf file that is in my Pronto. I don't think that you can import it into Pronto Edit 3 from what I recall. Is there a work around so that I can do it or am I stuck?
|
|
Post 2 made on Wednesday July 22, 2015 at 02:33 |
cosmicvoid Long Time Member |
Joined: Posts: | November 2007 104 |
|
|
Uploading code from the Pronto is not supported. Even if it was, you'd get binary, not source code.
Perhaps if you haven't overwritten the relevant area of your hard drive, you could use a file recovery utility to 'undelete' it.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.