| Post 1 made on Tuesday February 3, 2009 at 17:22 |
WilsonUAV Lurking Member |
Joined:
Posts: | January 2009
4 |
|
|
After learning all of the Dish's IR codes and setting them up in a TSU-9200 mcf with an RF Extender I've found that you must press the buttons twice for them to activate the box.. I noticed the box appears to have three IR receptors while the remote seems to have two emitters.
I'm simply a novice at this stuff so I'd appreciate any guidance, but can anyone tell me if there is a way to manipulate the mcf to work with a RF extender and ViP211 box?
|
|
| OP | Post 2 made on Wednesday February 4, 2009 at 14:25 |
WilsonUAV Lurking Member |
Joined:
Posts: | January 2009
4 |
|
|
Any help would be greatly appreciated.
Thanks
|
|
| Post 3 made on Wednesday February 4, 2009 at 14:33 |
thoupis Long Time Member |
Joined:
Posts: | August 2007
124 |
|
|
Are you sure you learned the codes correctly? Perhaps too small instead of the standard length? You can either change the emition rate or relearn the codes.
|
|
| OP | Post 4 made on Monday February 9, 2009 at 14:01 |
WilsonUAV Lurking Member |
Joined:
Posts: | January 2009
4 |
|
|
Problem has been solved by pressing each button on the Dish remote twice quickly during the learning process...
|
|
| Post 5 made on Monday February 9, 2009 at 18:02 |
GuerillaBuild Long Time Member |
Joined:
Posts: | December 2008
79 |
|
|
You may also want to tell the MyDatabase commands to repeat rather than do a single send. It sounds like your device requires some form of repeating signal. FYI I'm using a TSU9400; thus you may have more limitations with the 9200.
|
You can hide almost anything until you have to put the drywall up! |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
