Does Pronto Professional TSU9600 work with Lutron Grafic Eye 3000 series?

Don't think so. Did you search and read the help files from Philips?

The document only quotes Lutron RA but when i called the distributor RGB Comms , they said it will work. I would like to confirm before buying

Din

If the Grafix Eye is IR, it will work fine. I have done some Grafix Eye units that were IR and no problems.

Dave

I stand corrected. Thanks Dave....

Lyndel

All Grafik Eyes are IR and will work with the 9600 as an IR device. As they are using IR, the pre configured interface for Lutron is not applicable however.

Lutron has RS-232 controllable Graphic Eyes, getting the wire there could be an issue though.

The RS232 capability of the upper end Grafik Eye products is not the same protocol as the RS232 RA interfaces and would only work as one way communication. The pre configured Lutron interface will still not apply but you could use RS232 if desired.

The GrafikEye will work fine with the TSU9600 using the IR codes in the factory database. However if you have the optional Lutron Professional IR receiver for the GrafikEye, you can use the extended Lutron IR codes that allow individual GrafikEye units and all zones on each unit to be addressed individually.

The GRX-RS232 interface will permit the RFX9600 to control one to eight GrafikEyes too, but there cannot be any feedback to the TSU9600. The codes are plain ASCII so easy to type in, but are of course different from RadioRa.