Your Universal Remote Control Center
RemoteCentral.com
General Pro Remotes Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Topic:
URC MRX-10 Stuck in start up.
This thread has no replies.
Post 1 made on Thursday October 27, 2016 at 12:15
bmmurdoch
Junior Member
Joined:
Posts:
October 2016
1
Has anyone seen a MRX-10 get stuck in start up mode? When it starts up the power light simply flashes about once every second. nothing changes when I plug in an ethernet cable. Performing a hard reset by holding down the reset button for 15 seconds does not seem to make a difference. I am also unable to discover the device in the URC Accelerator software.

URC's tech support thinks that the device is likely bad (and out of warranty). Has anyone else seen this issue and found a solution?

Thank you!

Jump to


Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse