Post 1 made on Monday April 19, 2010 at 16:18 |
I ahve an harmony 890 and it has been working great until i just got a dish network VIP 612 DVR. it will not operate the DVR using the wireless extendor (IR extendor).
Any idea why? Pls help.
thanks
|
|
Post 2 made on Monday April 19, 2010 at 17:20 |
kugie Only One Remote |
Joined: Posts: | March 2006 57 |
|
|
live4sking,
Every dish receiver I have seen in the last several years has been shipped in rf mode. You can re-set it to ir mode in the dish setup menu.
Stan Kay Only One Remote Inc.
|
|
OP | Post 3 made on Saturday May 8, 2010 at 11:49 |
|
Post 4 made on Saturday May 8, 2010 at 15:04 |
kugie Only One Remote |
Joined: Posts: | March 2006 57 |
|
|
live4sking.
Just curious...did Dish not provide you with a manual? Nothing would surprise me there days.
ALL DISH UNITS ARE RF OUT OF BOX YOU MUST PERFORM THIS PROCEDURE
1.Press SYS INFO button to display current remote address. 2.Press and hold SAT button for three seconds until all of the mode buttons light up and then release. 3.Use numeric keypad to enter the new address (1-16). Use address #1 for IR operation 4.Press POUND (#) button. If you entered the address correctly, the remote will flash three times. 5.Press the record button. Note: Insure that the new address shown on screen is the number that you entered. 6.Press the SELECT/OK button to close the sys info screen.
Use address #1
Regards,
Stan Kay Only One Remote Inc.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.