Post 1 made on Monday July 25, 2011 at 16:35 |
Hi,
I'm new to RTI remote programming and have a question about IR/RF. I'm programming the T3V+ and cannot get the IR to work on the TV. Other equipments on RF and works fine. I changed the output to all that was available and no luck. I'm assumming i have to create a macro for the TV to be able to use IR. Any help would greatly appreciated. Thanks
NEWBIE
|
|
Post 2 made on Monday July 25, 2011 at 17:56 |
kstrange Long Time Member |
Joined: Posts: | February 2007 379 |
|
|
Set remote properties to RF. Change the "Watch TV" button (or whatever it is) properties to Standalone. Then the button will not be bound to the remotes RF properties.
You will need to create a "System Macro" on the processor for your RF sequence.
Create your macro for the "Standalone" button with IR commands for TV and the appropriate "System Macro" command for your RF sequence.
|
|
Post 3 made on Wednesday July 27, 2011 at 22:02 |
SOUND.SD Loyal Member |
Joined: Posts: | April 2006 5,523 |
|
|
Fellow San Diegan. Welcome to the forum. The above answer is correct. If you run into issues feel free to call. Better projects in the community is good for the industry.
|
Bulldog AV - San Diego, CA www.bulldog-av.com[Link: facebook.com] |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.