Post 1 made on Wednesday September 28, 2011 at 15:57 |
smittylube Lurking Member |
Joined: Posts: | December 2006 2 |
|
|
Hi guys, New house, buyer wanted my older TV's and such. Starting fresh. 60" Aquos ATT uverse. HDMI connected. I was able to get the ATT remote to work the TV, but some of the commands don't work. I have used the $30 sony programmable in the past, but would like to use only the sharp remote if I can. I have tried pretty much all the codes listed in the manual and more to no avail.
The codes they say are only 2 digit codes. I tried from 01- 38 no dice. Choose devise and while holding it push display/ flashes then stops after code..
If anyone has any ideas I would appreciate it. I have even gotten the netflix and such working fine through the TV wifi.
It says Cisco on the front of the STB uverse box. If that helps
Thanks , Steve
|
|
OP | Post 2 made on Monday October 3, 2011 at 12:52 |
smittylube Lurking Member |
Joined: Posts: | December 2006 2 |
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.