Post 1 made on Wednesday April 20, 2005 at 07:14 |
Hi
I am trying to configure my iPAQ to automatically connect via Bluetooth (using the LAN profile) to my PC.
So far I have successfully setup the BT network. Unfortunately I always have to initiate the connection manually.
My Goal is to use the iPAQ as remote control together with NETremote, Girder and IRtrans. I could use WLAN instead of BT, but WLAN uses too much power.
Does anybody know how to do this? Any suggestions?
Thanks!
Flexi
|
|
Post 2 made on Sunday April 24, 2005 at 03:36 |
See and try if this app works on your Ipaq: [Link: firstloox.org]It works great on my Pocket Loox 720, switching both bluetooth and wifi on and off automatically
|
|
OP | Post 3 made on Monday May 2, 2005 at 04:05 |
Thanks Guido66
I will try this little utility as soon as I can :-)
Is it just turning on/off BT and WLAN, or can it also connect to a specific BT profile? I have checked out the OzBT Website, but unfortunately I was not able to find an answer to this question there.
Thanks. Flexi
|
|
Post 4 made on Friday May 6, 2005 at 12:46 |
No, I don't think you can do that. It's just turning BT of WLAN on/off. Which is enough for me :-)
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.