| Post 1 made on Thursday December 19, 2002 at 14:03 |
programmergeek Founding Member |
Joined:
Posts: | September 2001
207 |
|
|
What am I doing wrong? I loaded my .cff file and non of the hard coded buttons work. The buttons on the bottom of the pronto I use to jump to different screens.
|
|
| Post 2 made on Thursday December 19, 2002 at 15:47 |
XRay Long Time Member |
Joined:
Posts: | November 2002
45 |
|
|
I found that you must configure the hard buttons on EACH device's properties page. Even if you want the hard buttons to act the same regardless of the device selected, as I do. It's not good enough to set up the hard buttons just on the System Properties page, you must duplicate the settings on each device's properties page.
Hope that helps. Jay.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
