Post 1 made on Tuesday March 26, 2002 at 12:36 |
Apologies for this newbie question, but I can't seem to find the information that I require. I have been pretty much all over the web until I landed here and realised that this was the place. So, the question: I am trying to emulate a particular infrared code RC6 (aka codeset 4, key 235) for example a code produced by a OneForAll remote. I would like to make this code from my PDA: an iPAQ using UltraRemote, PocketRemote, or TV Remote Controller. I can't don't see how I can "program" the PDA software to send this particular codeset/key. From reading other posts, I suppose that I should use a CCF file, but where can I get a appropriate CCF file or how can I make an appropriate CCF file. Back to the Pronto web site?
|
|
Post 2 made on Wednesday March 27, 2002 at 09:18 |
Anthony Ultimate Member |
Joined: Posts: | May 2001 28,874 |
|
|
go to the file section on this site, and download ProntoEdit V1.05 and install it. Add a panel under home and open it. dblclk one of the buttons on the panel and then the action tab....
|
... |
|
OP | Post 3 made on Wednesday March 27, 2002 at 09:49 |
Thanks, Anthony. Have already started with ProntoEdit and downloading some CCFs from RC's file archive. The trick is to find the right ones so that I don't have to start from scratch. Thanks again for the explanation of how to send a specific RC code.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.