Okay, so I'm still learning RS232 control in general...I'm a total newb. I've done a few system with RTI, but have yet to do anything with Crestron/Prodigy.

I am installing a Atlong 4x2 Component matrix AT-COMP-42M and would like to control it via 232. I couldn't find an existing module for it and I can't really remmeber how to make one. I know we touched on it in the SB training that I attended, but just for a minute and I there was a lot to take in.

Here is the manual with the 232 protocol on page 7:
[Link: atlona.com]


So can anyone help?

Use a SIO and SBUDxx01 etc. to send commands
SBUD0101 = Input 1 to output 1
SBUD0201 = Input 2 to output 1
SBUD0301 = Input 3 to output 1
SBUD0401 = Input 4 to output 1
and so on...

The above is what I would do in SW, I do not use SB at all so it might be a bit different.